D-GA44Q FUEL DISPENSER

D-GA44Q FUEL DISPENSER

FlowMeter Type: Optional

Accuracy: ±0.2%

Pressure Loss (kg/cm): Under 0.25

Motor Voltage(V): 110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle: Auto Shut-off Nozzle

Environmental Condition: -40~~+55degree

Control Type: Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter): Type LCD and Bright Backlight

Digit of Volume :0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price :0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional Display: Type LCD and Bright Backlight

Digit of Volume :0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range : 0~~99,999,999,99

Totalizer :1~~9,999,999

Hose: 4.5m

Weight : 335kg.

Dimension(L×W×H): 1270 x 620 x 2420(mm)

Dimension(L×W×H)Of Qty of Container: 40ft: 45 20ft: 22

As past over long service time, parts abrasion universally or cylinder severely damaged, a new measurement transducer should be installed to replace old one. As find exterior leakage, firstly inspect the bolts corresponding to leak section. Tightly screw loose bolts, if leakage is continued, disconnect and inspect the seal ring and gasket relative section. Substitute aging or damaged parts and reassemble. Apart from the above reasons of extensive colloid and surface abrasion, these trouble also cause abnormal operation of measurement transducer, such as position pin fall down from piston or deformation, small ax fuel dispenser is lost on upper and lower connecting rod, loose bolt between piston and connecting rod. The solution is that disassembling measurement transducer, replace damaged or unqualified components and reassemble. The products made in normal factory seldom appear these troubles. Since measurement transducer is core component of fuel dispenser, elaborate machining, disconnection and reassembly should be as careful as possible. All elements should be cleaned before reassembly, excluding water into inner. Bolts are tightened even and appropriately. Soft-piston measurement transducer As these merits --- small in size, light weight, beautiful appearance, high accuracy, piston exchangeable--- soft-piston measurement transducer is widely adapted in domestic fuel dispenser market. It generally involves two stru fuel dispenser ctures: four-piston structure and double-piston structure. The latter model is selected universally. Therefore, this article will introduce the structure, working principal and maintenance of four- piston measurement transducer. Structure Diagram 2-20 and Diagram 2-21 show the cutaway view and exploded drawing of four-piston measurement transducer that is widely employed. The transducer mainly consists of sealed cover, upper subassembly, export axis, frame subassembly, piston subassembly, connecting rod and top cover, clearly presenting in Diagram 2-20 and Diagram 2-21. Diagram 2-20: Cutaway view fuel dispenser

a readwrite mechanism.　　 Six basic messages are used to access any data in the system:　　 - Read Messages　　 - Answer Messages　　 - Write Message　　 - Unsolicited Data Message with Acknowledge　　FP2_1.90 IFSF STANDARD FORECOURT PROTOCOL February 2006　　 COMMUNICATION SPECIFICATION　　Page: 10　　 - Unsolicited Data Message without Acknowledge　　 - Acknowledge Message　　 A Read Message allows an origin fuel dispenser ator device to read the value(s) of any system　　 data element from a recipient device within a specified database. It is possible to read　　 multiple data elements in one command. This is achieved by requesting a list of data　　 elements. So only the accessible data elements must be requested and the messages　　 are application dependent. The recipient must respond to the Read Message with an　　 Answer Message within the time-out period of 8 seconds. However if a recipient　　 node is unable to respond it must reply with an ACK. If for instance the device was　　 busy it replies with a MSG_ACK of NAK7 or if the Read Message contains an　　 invalid database address the device replies with a MSG_ACK of NAK6.　　 fuel dispenser An Answer Message is a message which provides to the originator of a Read　　 Message all the requested data elements.　　 A Write Message is used to send data from an originator to a recipient device. The　　 identifier of the data element is defined in the recipient device. It is possible to write a　　 multiple data elements in the one command. This is achieved by issuing a message　　 including a list of data elements and their values.　　 Sending a Command is considered as writing fuel dispenser

upposed to have traded in war, nationalism and conflict for love, peace and federalism. But Israel now reminds Europeans of darker forces and darker days. Could attitudes change? It seems unlikely, not least because Israel is now so stridently critical of the Europeans, especially of their media. In this area, at least, the transatlantic gap is widening.  © 2006 .  About sponsorship Günter Grass Another hero lost Aug 17th 2006 | BERLIN From The Economist print edition A left-wing firebrand comes clean about his murky past REALITY can be fuel dispenser stranger than fiction, even for such an inventive novelist as Günter Grass, author of the 1959 novel “The Tin Drum� which started a career that led to the Nobel Prize for literature in 1999. After a lifetime of prodding Germans to come clean over their Nazi past, the 78-year-old writer has caused uproar by publicly confessing that, during the war, he was not just an assistant on anti-aircraft batteries, but a member of the Waffen-SS. Mr Grass said in an interview that he volunteered for submarine duty but was instead called up in 1944, at the age of 17, to join a tank division of the Waffen-SS. Mr Grass says he did not fire a shot, was injured in April 1945 and taken prisoner-of-war by American troops. What irks his critics is that this confession comes 60 years late—and from a man who set fuel dispenser himself up as Germany s moral conscience in facing up to the Holocaust. There have been plenty of chances, they say, for him to come clean, such as the 1985 visit by Chancellor Helmut Kohl and President Ronald Reagan to the military cemetery in Bitburg, where some Waffen-SS members were buried. Mr Grass was an outspoken critic of that visit. Speculation is rampant about why Mr Grass kept quiet for so long—and why he chose to speak out only now. To his harshest critics, it has much to do with ambition and salesmanship. If his past had been known, they say, he would never have been con fuel dispenser